PuraFlame 36" Vivian Wall Mounted Curved Panel Electric Fireplace with Remote Control, 1500W, Black
Wall mounted curved panel electric fireplace heater.
Thermostat automatically turns the heater on and off to maintain the room temperature from 60¡§H to 84¡§H. The timer turns off the fireplace at the set time, from 0.5 hours to 9.0 hours.
The LED backlights turn on in alternating 3 multi-color mode. LED flame brightness cycles through 3 levels.
Supplemental heat for up to 400 sq.ft. Dimensions: 35.8" L X 5.7" W X 24.4" H. One year Warranty.
Quiet air outlet is at the bottom of the fireplace, 1500W fan heater for rooms up to 400 square feet.
Control panel ON/OFF switch must be ON to use remote control.
The Power cord is lengthened to 1.8 meters.
Easy to use, install and uninstall.
One year Warranty.
l Why does the fan blow before the heat comes on, and after the heater is turned off?
Heat and cool gradually. The fan blows when the heater is first turned on, and the heat is still heating up. After the heater turns off, the fan will continue to blow air for 10 seconds. This allows the fireplace to cool slowly, and helps prevent overheating.
l What does the fireplace beep? Can I turn the beeping off?
The beeps indicate that the signal from the control panel, or remote control, has been received by the fireplace. The beeping cannot be turned off.
l Why doesn¡¯t the fireplace function change when remote control setting changes?
The fireplace function will only change if there is a beep after pressing the button. If you do not hear a beep, try again. If you hear a beep, the fireplace function will change to match the remote control setting. For example, if the heat is on, but the remote control screen reads off, press the heater button again. The heat symbol will display. Both are now ¡°on¡±. Press the button again, and wait for the beep. The heater and the heat symbol will both turn off.
l Why does the remote control not work, or only work sometimes?
Check to make sure the batteries are good. If necessary, change to new batteries. If the remote control is not aimed properly, if you are too far away, or if you are too far off to the side, the signal may not reach the fireplace. Get closer, aim at the upper right corner of the screen (where the red heat indicator light is located), and try again.
l How do I change from high heat to low heater?
There is no high heat, or low heat. The heater is controlled by the heater button on the control panel, or the heater and temp buttons on the remote control.
l Is the thermostat setting accurate?
The temperature within a room can vary. Room size, fireplace location, air flow, sunlight, wall type (interior vs. exterior), insulation, etc. all affect temperature. The fireplace setting may not match your home thermostat exactly. This is normal. Try different thermostat setting on your fireplace until you find one that is right for you.
l How do I turn off the LED backlights?
The backlights turn on with the flame effect, and can only be turned off with the remote control.
